FREE Roofing Estimates
24 Hour Roof Replacement Guarantee
Call Icon
    Top

Call Our Roofing Experts! (504) 800-8196

Gutter Repair in Baton Rouge, LA

Big Easy Roofing repairs gutters and downspouts across Baton Rouge and East Baton Rouge Parish, priced per defect rather than per foot. Baton Rouge takes about 62 inches of rain a year and it arrives in short heavy bursts, and it is that intensity rather than the annual total that decides whether a run copes in a downpour.

$150 to $600Estimated per defect
1 visitTypical gutter repair
No permitRepair, not construction
4.0 in/hrWhat gutters size against

Baton Rouge gutter repair at a glance

A gutter repair is a scoped fix for a single defect: a sagging run re hung on new hangers, a leaking seam re sealed, a blocked downspout cleared, or a torn end cap replaced. A single defect repair is typically estimated at $150 to $600 and finishes in one visit.

Estimated per defect

$150 to $600

A single defect repair on a residential gutter, priced after an on site diagnosis. Call Big Easy Roofing on (504) 800-8196 and we will walk every run and photograph each defect before anything is quoted.

Multi defect visit

$600 to $1,800

Two or more defects on the same visit, such as several sagging runs, a few failed seams and a torn end cap, priced as one bundled scope rather than as separate call outs.

Who issues the permit

East Baton Rouge Parish

The parish is the permitting authority for Baton Rouge addresses, but a gutter repair is not a roof covering change, so the re roofing rule that came in during 2025 does not reach it and no permit is pulled for a repair only visit. Where a job grows beyond the gutter we confirm the position with the parish before starting.

Repair or replace

Under 3 defects

Under three defects on an otherwise sound run usually means a repair. Three or more on the same run usually means the sealant, the coil stock or the fascia fixing behind it is at the end of its life, and replacing that run is the better value.

What gutters size against

4.0 in/hr

NOAA records a 100 year recurrence rainfall rate of 4.0 inches per hour for Baton Rouge Ryan Field. Gutter capacity is worked out from the roof area feeding a run and the rainfall rate it is sized against, which is why a run that copes in a gentler climate can struggle here.

Warranty

1 yr workmanship

One year workmanship warranty on the repair we carry out, whether that is the sealant, the hangers, the re seat on the fascia or a replacement run.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Cost and timescale depend on size, pitch, access, weather, materials and whatever is found once work starts, so call Big Easy Roofing on (504) 800-8196 and we will come out and give you an estimate for your own roof.

A gutter usually gets a call when water is doing something it should not. It sheets over the front edge in the middle of a run, it drips down the fascia and stains the wall, it pools at the base of a downspout, or a section has visibly dropped away from the roof line. Each of those has a different cause and a different fix, which is why the diagnosis comes before the price rather than after it.

The one worth understanding before you call anyone is overflow, because it gets misdiagnosed more often than it should. The standard answer is that the gutter is blocked, and often it is. But a gutter has a fixed capacity, set by its size, its fall and the number of downspouts against the area of roof draining into it, and Baton Rouge asks more of that capacity than most of the country does. A clean gutter that still overflows in a heavy storm is not dirty. The usual reasons are that it is undersized for the roof feeding it, has too few outlets, or has lost its fall, and which one it is can be checked.

That distinction decides whether cleaning it again is money well spent. If the run is undersized, it will overflow every time the rain is hard enough, however often it is cleared, and the water that comes over the front edge is a common cause of rot in the fascia board behind it. We will tell you what we find and price the honest fix rather than the repeat visit.

Common gutter defects and typical scope

Gutter repairs fall into seven classes. The table gives the typical scope, the estimated price band and how long each takes on site. Under three defects on one sound run is usually a repair. Three or more usually means replacing the run beats stacking fixes.

Defect classWhat we doEstimated price bandVisit length
Sagging run, one to three hangersRe hang on new hidden hangers, re seat to the fascia$150 to $3501 to 2 hours
Leaking seam or cornerClean the seam, re seal with butyl, re bed the corner joint$150 to $3001 to 2 hours
Blocked downspoutClear the blockage, flush through, test the flow at the outlet$150 to $2501 hour
Torn end cap or missing splash blockReplace the end cap and re seal, or fit a new splash block$150 to $3001 hour
Wind damaged downspoutRe hang or replace the downspout section and secure it to the wall$250 to $5002 hours
Fascia rot behind the gutterTake the section down, replace the rotten fascia, repaint, re hang$300 to $7002 to 4 hours
Whole run replacementStrip the failed run, form new seamless aluminium on site, re hang$600 to $1,800Half a day

Estimated ranges, not quotes, and none of them includes a capacity upgrade such as a larger profile or an extra downspout, which is priced separately once the roof area is measured. Call (504) 800-8196 and we will put the defect, the fix and the price in writing before anything starts.

Why a clean gutter still overflows and whether you need a permit

Two things decide most gutter repairs in this market. Why a run overflows when it was cleared only months ago, and whether the 2025 Louisiana roofing rule applies to gutter work at all. The short answers are capacity rather than dirt, and no, because a gutter is not a roof covering.

Baton Rouge rain is the reason

61.94 inches a year

The National Weather Service puts the 1991 to 2020 normal for Baton Rouge Ryan Field at 61.94 inches a year, with June the wettest month at 6.45 inches. A gutter here handles far more water over its life than the same gutter fitted in a drier state, and it is asked to do it in short heavy bursts rather than steadily.

Capacity is set against a rain rate

4.0 inches per hour

NOAA Engineering Weather Data publishes a 100 year rain rate of 4.0 inches per hour for Baton Rouge Ryan Field. Gutter and downspout capacity is worked out from the roof area draining into a run and the rainfall rate it is designed against, so a higher rate means the higher the rate, the smaller the roof area each downspout can safely handle.

Which is why cleaning does not always fix it

Undersized, not dirty

If a run is too small for the roof feeding it, or has too few outlets, it will overflow whenever the rain is hard enough no matter how recently it was cleared. The fix is a larger profile, an extra downspout, or a corrected fall, and we will say which rather than booking you a second clean.

A gutter repair needs no permit

Not a covering change

The rule that changed in 2025 covers roof construction and re roofing, and East Baton Rouge applied it to roof installations. A gutter is not a roof covering, so a gutter repair is outside it. If a visit turns into roof work we confirm the position with Permits and Inspections before continuing rather than after.

Overflow is a common cause of fascia rot, so the cheap fix is the early one

The damage from an overflowing gutter is rarely the water you can see. It runs over the front edge or back behind the run, and the board it lands on is the fascia, which is the timber the gutter is screwed to. Wet fascia holds moisture against the roof edge, the hangers lose their grip, the run sags further, and it overflows more.

That is a loop, and it gets more expensive at every turn. A sagging run re hung early is a couple of hundred dollars. The same run left for another couple of wet seasons can take the fascia with it, and once soffit and eave framing are involved it stops being a gutter job at all. A single unexplained sag is worth looking at for that reason alone.

What to ask any gutter contractor in this market

Ask what roof area drains into the run they are quoting, and what rainfall rate they are sizing it against. It is a fair question and it is answerable, because the calculation is roof area against rain rate against outlet capacity. If the answer is that they will fit the same size that is there now, you may be paying to reinstall the problem.

Ask, too, what happens if fascia rot is found once a section comes down, because it is common and it changes the price. On our scopes that is itemised as its own line and signed before the crew carries on, so nothing is added without your agreement.

Why gutters fail in this climate

Three patterns come up repeatedly on Gulf coast houses. Heat and humidity working on the joints, the sheer volume of water working on the fixings, and debris working on the outlets. Each has its own tell, its own fix and its own price band.

Seams giving way to heat cycling

A sectional gutter is watertight because of a bead of butyl or silicone at each lap joint. That bead expands and contracts every day of a Louisiana summer, and it is the usually the first part of the system to go, often within about a decade, and it fails at the joint rather than anywhere along the sheet.

The tell is a dark drip stain on the fascia directly under a joint, and a narrow wet patch on the wall below it during rain. One seam is a straightforward re seal. Several failing on the same run means the whole run is at that age, and a seamless replacement with no mid run joints at all is the fix that lasts.

Fixings pulled by the sheer weight of water and debris

A gutter full of wet debris is heavy, and after a hard Gulf storm it is carrying water on top of that. The load goes into the hidden hangers and into the fascia behind them, and they tend to let go progressively rather than all at once, which is why a run often dips in the middle first.

The tell is a visible sag and water sheeting over the front edge at the low point instead of running to the outlet. The repair is usually new hangers at a tighter spacing, once the fascia behind them has been checked, since a sag can also come from rot or failed fixings rather than spacing alone.

Outlets that block faster than the gutter does

The downspout outlet is the narrowest part of the whole system, so it can block while the gutter still looks clear from the ground. One blocked outlet is enough to flood a bed or a walkway in a single storm, while the rest of the run looks perfectly clean from the ground.

The tell is water overflowing at the downspout end rather than in the middle. Clearing it is quick and cheap. If it keeps happening, the honest answer is usually guards or a larger outlet rather than a standing appointment to clean it out.

Big Easy Roofing Process

Three steps and a free first visit. The diagnosis is per defect, so you can see what is being repaired and why before any number is agreed.

A roofer in a high visibility vest measuring a fascia and downspout run from a ladder
01

Free on site diagnosis

An estimator walks every gutter run, finds every defect and photographs each one, and checks whether the run is actually big enough for the roof draining into it. You keep the photographs whether or not you use us.

02

Written quote, defect by defect

The scope names each defect, the fix, the materials, the warranty and the price. Where three or more defects sit on the same run, replacing that run is priced against the sum of the repairs so the sensible call is obvious rather than argued.

03

Repaired, usually within the week

A gutter repair is typically finished in one return visit inside a week. The written price stands unless something behind the run changes the scope, and then it is amended in writing and signed before the crew carries on. Call (504) 800-8196 to book the diagnosis.

Everything else we do in Baton Rouge

The rest of the Big Easy Roofing services available in Baton Rouge, each with its own page, crew and written scope. Because gutter overflow is one of the things that soaks the wood behind the run, fascia work is often found at the same visit and priced with it.

Filter by service type: