Roof Flashing Repair in St. Rose, LA
Big Easy Roofing repairs flashing across St. Rose and the east bank of St. Charles Parish. The scope names the one detail that is failing, checks whether a wide chimney has the cricket the code calls for, and photographs the metal before and after.
St. Rose roof flashing repair at a glance
Flashing is the sheet metal or other material that sheds water where the roof covering meets something that breaks it, such as a chimney, a wall or a pipe. A St. Rose flashing repair names the detail that is most likely failing, and checks whether a wide chimney also needs the cricket the code calls for.
A specific detail, written down
The scope names the detail: chimney step flashing, counter flashing, wall junction, pipe boot, vent collar or edge metal. A scope that does not name it is more likely to be a guess.
Crickets behind wide chimneys
The 2021 International Residential Code, section R903.2.2, calls for a cricket or saddle on the ridge side of a chimney or other penetration wider than 30 inches, measured perpendicular to the slope. A cricket turns water around the chimney instead of letting it pool.
Flashing at a reroof
The reroofing provisions of the same code have two sections to know: R908.5 on reinstalling existing materials, including flashing and edging, and R908.6 on flashings themselves. We do not quote either, so ask the parish how they apply to your job.
Metal first, sealant second
If the metal is in good condition and only the sealant has failed, cleaning and re-sealing can be the right repair once it has been inspected. If the metal is corroded or bent, sealing over it only buys time.
A trace comes first
A leak trace points to which flashing is most likely letting water in, so the repair goes where the leak most likely is.
Your insurer decides cover
Louisiana R.S. 37:2159.1 bars a roofing contractor from acting as a public adjuster or interpreting insurance policy coverage. We write the scope and photograph the detail.
Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Cost and timescale depend on size, pitch, access, weather, materials and whatever is found once work starts, so call Big Easy Roofing on (504) 800-8196 and we will come out and give you an estimate for your own roof.
Every price on this page is an estimate, not a quote. Call Big Easy Roofing on (504) 800-8196 to look at a flashing on your St. Rose roof.
Which flashing is failing, and what the repair involves
Flashings are not interchangeable. The table lists the common cases, where each sits on the house and what each repair involves, so you can see which detail is being discussed, and what it is estimated at, before any work starts on your St. Rose roof.
| Flashing | Where on the house | What the repair involves | Estimated |
|---|---|---|---|
| Chimney step and counter flashing | Where the chimney meets the roof | Old step flashing cut out, new installed, counter flashing re-sealed or reset | $500 to $1,500 |
| Chimney cricket | Ridge side of a wide chimney | A saddle, usually sheet metal, built behind the chimney and flashed in | Scoped on site |
| Wall junction flashing | Where a roof meets a vertical wall | New flashing installed under the wall cladding or counter-flashed into masonry | $350 to $1,200 |
| Pipe boot or vent collar | Where a pipe passes through | Old boot cut off, new one installed and sealed | Scoped on site |
| Edge metal and drip edge | At eaves and rakes | Rusted or damaged edge metal replaced | Scoped on site |
Every price is an estimate and none of it is a quote. The headline band for a flashing repair is $350 to $1,500, and a chimney that needs a cricket is priced on its size.
What the code says about flashing and crickets
Two sections of the residential code are worth knowing on a St. Rose flashing job: the cricket rule for wide chimneys, and the reroofing sections on existing flashing. The 2021 code, with state amendments, is the statewide edition, and the parish says how it applies to a given address.
The code in force
Louisiana adopted the 2021 International Residential Code, with state amendments, from 1 January 2023, which includes St. Charles Parish. Its chapter 9 covers roof assemblies.
Crickets and saddles
A cricket or saddle goes on the ridge side of a chimney or penetration wider than 30 inches, measured perpendicular to the slope. Its covering is sheet metal or the same material as the roof covering.
Flashing at a reroof
R908.5 deals with reinstalling existing materials in a reroof, including flashing and edging, and R908.6 is the section titled Flashings. They are the sections to ask the parish about when flashing is part of a reroof.
What the parish decides
Whether a particular flashing scope needs a permit is for St. Charles Parish Planning and Zoning on (985) 783-5060. How the parish has treated repairs is on the repair page, and a full reroof is on the replacement page.
Why a missing cricket can keep a wide chimney leaking
Water running down the slope hits the uphill side of a wide chimney and pools there. Re-sealing that joint without a cricket can fail again in the next heavy rain.
We measure the chimney first. If it is 30 inches wide or less, that rule does not call for one, and we say so.
What we do not tell you
We do not say any particular chimney needs a cricket until we have measured it, and we do not say a flashing job is exempt from a permit. That is the parish’s call.
We write the scope specifically enough that the parish can answer.
Why flashing fails on a St. Rose house
Flashing tends to fail at the same few places, and for the same few reasons. Knowing them is how a repair lands on the right one, and why the scope reads the metal and the older repairs rather than only the sealant on top.
Heat and damp work on the sealant
A roof here can see frequent heating, cooling and humidity. Sealant at a flashing moves with it and can lose its grip over the years, sometimes before the metal itself has failed.
That is why the scope reads the condition of the metal, not only the sealant above it.
Rain pushed sideways
In a storm, rain is driven against the back of a vent cap, the face of a chimney and the side of a dormer. Those are surfaces that get less direct rain in ordinary weather.
A flashing can read clean from one side and be failing on the other, so both sides are photographed.
Older repairs hide the real fault
A flashing that has been sealed over more than once can be a sign the leak was chased rather than found. Layers of sealant can hide a split or a gap in the metal beneath.
The scope may cut back to bare metal to see what is there before it decides between re-sealing and replacing.
Big Easy Roofing Process
Four steps. The flashing is photographed before anything is cut, so the scope and the finished work are tied to the same evidence.

01 Find the failing detail
A leak trace points to the flashing most likely letting water in. The detail and the roof around it are photographed.
02 Measure and write the scope
The chimney width is measured for the cricket question, and the scope names the detail, the metal and the method.
03 Check the parish
A call to St. Charles Parish Planning and Zoning on (985) 783-5060 checks whether the scope needs a permit for your address.
04 Cut, install and photograph
Old flashing cut out, new installed and sealed following the manufacturer instructions where they apply, and the finished detail photographed before the ladders come down.
Everything else we do in St. Rose
The rest of the Big Easy Roofing services available in St. Rose, each with its own page and written scope. A flashing repair usually follows a leak trace, which points to the likely entry point so the scope knows where to cut.

Roof Replacement in St. Rose
Read More
Roof Repairs in St. Rose
Read More
Roof Inspection in St. Rose
Read More
Hail Damage Roof Repair in St. Rose
Read More
Storm Damage Roof Repair in St. Rose
Read More
Storm Damage Emergency Response in St. Rose
Read More
Emergency Roofing in St. Rose
Read More
Roof Leak Detection in St. Rose
Read More
Roof Maintenance in St. Rose
Read More
Roof Coating in St. Rose
Read More
Roof Ventilation in St. Rose
Read More
Roof Weatherproofing in St. Rose
Read More
Roof Restoration in St. Rose
Read More
Fascia Board Installation and Repair in St. Rose
Read More
Gutters and Downspouts Installation in St. Rose
Read More
Gutters and Downspouts Repair in St. Rose
Read More
Siding Installation in St. Rose
Read More
Asbestos Roof Removal in St. Rose
Read More
Roof Damage Documentation in St. Rose
Read More
Commercial Roof Replacement in St. Rose
Read More
Commercial Roof Repairs in St. Rose
Read More
Commercial Roof Inspections in St. Rose
Read More
Commercial Hail Damage Repair in St. Rose
Read More
Commercial Re-Roofing in St. Rose
Read More
Commercial Roof Coating in St. Rose
Read More
Commercial Elastomeric Coatings in St. Rose
Read More
Commercial Roof Ventilation in St. Rose
Read More
Commercial Roof Leak Detection in St. Rose
Read More
Commercial Siding Installation in St. Rose
Read MoreSt. Rose Roof Flashing Repair FAQs
The questions worth asking before a flashing repair on a St. Rose roof.
Topic
Question not here?
Ask us anything about a flashing on your St. Rose roof. No charge to ask.
Call (504) 800-8196Which flashings do you repair?
Chimney step and counter flashing, wall junction flashing, pipe boots, vent collars and edge metal at eaves and rakes. The scope names the specific detail.
Can you re-seal a flashing without cutting it out?
Sometimes. If the metal is sound and only the sealant has failed, cleaning and re-sealing can be the right work once it has been inspected. If the metal is corroded or bent, re-sealing it is a short term fix.
What is a chimney cricket?
A small ridge, usually sheet metal, built on the uphill side of a chimney that turns water around it instead of letting it pool. The 2021 International Residential Code, section R903.2.2, calls for one behind a chimney or penetration wider than 30 inches, measured perpendicular to the slope.
Does my chimney need a cricket?
Under that section, a cricket is called for when the chimney is wider than 30 inches measured perpendicular to the slope. We measure it before we say, because a chimney 30 inches wide or less is not covered by that rule.
What do the reroofing sections say about flashing?
In the 2021 International Residential Code, R908.5 deals with reinstalling existing materials in a reroof, including flashing and edging, and R908.6 is the section titled Flashings. We do not quote either. Ask St. Charles Parish Planning and Zoning on (985) 783-5060 how they apply to your job.
What does flashing repair cost in St. Rose?
A flashing repair is estimated at $350 to $1,500, driven by the length of the run, access and whether the metal is sound. A chimney cricket is priced on its size. Every figure is an estimate.
Does a flashing repair need a parish permit?
That is for St. Charles Parish Planning and Zoning to say for your address, on (985) 783-5060.
Will you handle my insurance claim?
No. Louisiana R.S. 37:2159.1 bars a roofing contractor from acting as a public adjuster or interpreting insurance policy coverage. We write the scope and photograph the detail.
Name the detail, measure the chimney before any flashing is cut
A flashing scope that names the specific detail, measures the chimney for a cricket and photographs the metal before and after gives the repair the best chance of holding. If you would rather start in writing, tell us what the job involves and we will come back with an estimate.
Call (504) 800-8196



