Fascia Board Installation and Repair in St. Rose, LA
Big Easy Roofing installs and repairs fascia across St. Rose and the east bank of St. Charles Parish. The scope replaces the rotten board, checks the edge metal above it and the gutter beside it, and writes down what is most likely to have caused the rot.
St. Rose fascia board installation and repair at a glance
Fascia is the trim board along the roof edge, and it is the board a gutter usually hangs from. A St. Rose fascia job replaces the rotten sections, and in our experience the part that often decides whether the repair lasts is the metal above the board, so the scope checks the drip edge.
The edge metal comes first
In our experience a missing, short or rusted drip edge is a common reason fascia rots from the top. The scope records the condition of the edge metal before the new board goes on, so the repair is not fitted under the cause.
Drip edge at eaves and rakes
The 2021 International Residential Code calls for a drip edge at the eaves and rake edges of a shingle roof, with lengths lapped by not less than 2 inches where they join. We read that as a reason to check the metal, not as a promise about any one house.
Worn edging is replaced, not reused
In a reroof, the same code has existing flashing, edging, outlets and vents that are rusted, damaged or deteriorated replaced rather than reinstalled. Whether and how the parish applies that to a fascia job is for the parish to say.
Match what is on the house
A short run replaced with a board of a different depth can look wrong from the street. The scope notes the existing profile and the material, and the replacement is fitted to match it.
Check the gutter too
An overflowing gutter wets the face of the board and the soffit behind it. If the gutter started the rot, replacing the fascia alone leaves the cause in place.
Your insurer decides cover
Louisiana R.S. 37:2159.1 bars a roofing contractor from acting as a public adjuster or interpreting insurance policy coverage. We write the scope and photograph the damage.
Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Cost and timescale depend on size, pitch, access, weather, materials and whatever is found once work starts, so call Big Easy Roofing on (504) 800-8196 and we will come out and give you an estimate for your own roof.
Every price on this page is an estimate, not a quote. Call Big Easy Roofing on (504) 800-8196 to look at the fascia on your St. Rose house.
What rots a fascia board, and what the repair involves
In our experience, fascia rot often has a cause above or beside it. The table sets out the usual causes, what we check, what the repair involves and what it is estimated at, so the fix reaches the cause as well as the board.
| Cause | What we check | What the repair involves | Estimated |
|---|---|---|---|
| Missing or short drip edge | Whether a drip edge is there and lapped | Rotten section cut out, new board fitted, drip edge added or lapped | $300 to $700 a section |
| Rusted or damaged edge metal | Corrosion along the eave and rake | Rusted metal replaced together with the rotten board under it | Scoped on site |
| Overflowing gutter | Outlets, fall and hangers | Board repaired and the gutter problem named in the scope | $300 to $700 plus gutter work |
| Paint failure and soft timber | Cracked or bare paint, soft spots | Soft timber replaced, new board primed on all faces and painted | Scoped on site |
| Full run replaced | Length of the run and access | Whole fascia run taken off and renewed along the elevation | Priced on the run |
Every price is an estimate and none of it is a quote. The rot is opened up before the price is final, because it often runs further along the board than the stain suggests. Prices can change, so call to confirm the figure for your house.
What the code says about the roof edge
Two lines of the residential code bear on the metal that sits above a fascia board. The 2021 International Residential Code is the statewide edition, and St. Charles Parish says how it applies to a given address.
The code in force
Louisiana adopted the 2021 International Residential Code from 1 January 2023, which includes St. Charles Parish. Its chapter 9 covers roof assemblies.
Drip edge
A drip edge is called for at the eaves and rake edges of a shingle roof, and lengths that join are lapped by not less than 2 inches. We paraphrase the section here and do not quote it.
Edging at a reroof
In a reroof, existing flashing, edging, outlets and vents that are rusted, damaged or deteriorated are replaced rather than reinstalled. The next section, R908.6, is the one titled Flashings. The repair page covers repairs more widely.
What the parish decides
Whether a fascia scope needs a permit is for St. Charles Parish Planning and Zoning to say, on (985) 783-5060. We write the scope specifically enough that the parish can answer.
Why the metal is checked before the board
Water that gets behind a short or rusted drip edge runs onto the top of the fascia and the end grain of the board. A new board fitted under the same failing metal can start to go the same way.
That is our reasoning from the work, not a line in the code, and we label it as ours.
What we do not tell you
We do not say a fascia repair is or is not a reroof, and we do not say it is exempt from a permit. Both are the parish’s call. The Herald Guide reported on 14 September 2021 that parish Planning and Zoning required a permit except for work on under 10 percent of a roof’s shingles, and whether a fascia scope falls under that is for the parish to say.
We do not say the code requires a particular repair on your house until the edge has been looked at.
Why fascia rots on a St. Rose house
Fascia tends to rot from the top, from the gutter side and from the face. Knowing which one you have is how a repair lands on the cause, and why the scope looks above and beside the board before it cuts anything out.
From the top
A missing, short or rusted drip edge lets water run back under the roof covering and onto the top of the board. Over seasons that water rots the fascia from the top down.
That is why the scope reads the edge metal and not only the board in front of it.
From the gutter
An overflowing or sagging gutter drops water onto the face of the board and into the soffit space. Heavy rain is when an outlet that is a little blocked shows up.
If the gutter was the cause, we say so and name the gutter work in the scope.
From the face
Wind-driven rain works on vertical surfaces. A board with bare, cracked or thin paint soaks it up and holds it for longer.
The scope specifies priming every face, including the cut ends, before the board is fitted, and painting once it is in place.
Big Easy Roofing Process
Four steps. The edge metal and the gutter are checked before the new board goes on, so the repair is not fitted under the cause.

01 Walk the fascia, the edge metal and the gutter
Rotten sections are found and marked. The drip edge above and the gutter beside the board are checked and photographed.
02 Write the scope
The scope names the sections to replace, the profile to match, the edge metal to add or replace and the likely cause.
03 Check the parish
A call to St. Charles Parish Planning and Zoning on (985) 783-5060 checks whether the scope needs a permit for your address.
04 Cut, fit, prime and photograph
Rotten board cut out, new board primed on all faces, fitted, then painted once in place, and the finished edge photographed before the ladders come down.
Everything else we do in St. Rose
The rest of the Big Easy Roofing services available in St. Rose, each with its own page and written scope. A fascia that keeps rotting often has a gutter problem beside it, and the two jobs often go together.

Roof Replacement in St. Rose
Read More
Roof Repairs in St. Rose
Read More
Roof Inspection in St. Rose
Read More
Hail Damage Roof Repair in St. Rose
Read More
Storm Damage Roof Repair in St. Rose
Read More
Storm Damage Emergency Response in St. Rose
Read More
Emergency Roofing in St. Rose
Read More
Roof Leak Detection in St. Rose
Read More
Roof Maintenance in St. Rose
Read More
Roof Coating in St. Rose
Read More
Roof Ventilation in St. Rose
Read More
Roof Weatherproofing in St. Rose
Read More
Roof Restoration in St. Rose
Read More
Roof Flashing Repair in St. Rose
Read More
Gutters and Downspouts Installation in St. Rose
Read More
Gutters and Downspouts Repair in St. Rose
Read More
Siding Installation in St. Rose
Read More
Asbestos Roof Removal in St. Rose
Read More
Roof Damage Documentation in St. Rose
Read More
Commercial Roof Replacement in St. Rose
Read More
Commercial Roof Repairs in St. Rose
Read More
Commercial Roof Inspections in St. Rose
Read More
Commercial Hail Damage Repair in St. Rose
Read More
Commercial Re-Roofing in St. Rose
Read More
Commercial Roof Coating in St. Rose
Read More
Commercial Elastomeric Coatings in St. Rose
Read More
Commercial Roof Ventilation in St. Rose
Read More
Commercial Roof Leak Detection in St. Rose
Read More
Commercial Siding Installation in St. Rose
Read MoreSt. Rose Fascia Board Installation and Repair FAQs
The questions worth asking before a fascia repair on a St. Rose house.
Topic
Question not here?
Ask us anything about the fascia on your St. Rose house. No charge to ask.
Call (504) 800-8196What is fascia and why does it rot?
Fascia is the trim board along the roof edge, and the board a gutter usually hangs from. In our experience it rots from the top when the drip edge fails, from the gutter side when the gutter overflows, and from the face when the paint fails and the board stays wet.
Do you install new fascia as well as repair it?
Yes. A short rotten section is cut out and replaced, and a longer run is taken off and renewed. The scope names which, and the length, before any price is final.
Why do you check the drip edge on a fascia job?
In our experience a missing, short or rusted drip edge is a common reason fascia rots from the top. The 2021 International Residential Code, section R905.2.8.5, calls for a drip edge at eaves and rake edges, lapped by not less than 2 inches where lengths join.
What does the code say about old edging?
In the 2021 International Residential Code, section R908.5 has existing flashing, edging, outlets and vents that are rusted, damaged or deteriorated replaced in a reroof rather than reinstalled. Ask St. Charles Parish Planning and Zoning on (985) 783-5060 how it applies to your job.
What does fascia repair cost in St. Rose?
A short section is estimated at $300 to $700. A longer run is priced on its length, access and how far the rot goes, and any gutter work is a separate line. Every figure is an estimate, and prices can change, so call to confirm.
Does a fascia repair need a parish permit?
That is for St. Charles Parish Planning and Zoning to say for your address, on (985) 783-5060.
What about the gutter above the fascia?
An overflowing gutter wets the board. If the gutter was the cause, we say so and name the gutter work in the scope, or you can read the gutter repair page.
Will you handle my insurance claim?
No. Louisiana R.S. 37:2159.1 bars a roofing contractor from acting as a public adjuster or interpreting insurance policy coverage. We write the scope and photograph the damage.
Check what is above, match what is there before the new board goes on
A fascia scope that checks the drip edge, the gutter and the paperwork route gives the repair the best chance of holding, and writes the likely cause down. If you would rather start in writing, tell us what the job involves and we will come back with an estimate.
Call (504) 800-8196



