Big Easy Roofing Logo
Claim Banner - Big Easy Roofing Big Easy Roofing roof replacement guarantee banner
Call Our Roofing Experts!(504) 800-8196
Home/Service Areas/Louisiana/Madisonville/Fascia Board Repair

Fascia Board Repair in Madisonville, LA

Big Easy Roofing repairs fascia boards across Madisonville and the Lake Pontchartrain shore of St. Tammany Parish. The parish’s own roofing sheet calls for a drip edge at eaves and rake edges, and in our experience the metal above a rotten fascia board is usually where the water came from.

$300 to $700Estimated per section
2 inch overlapDrip edge on the parish roofing sheet
Find the causeOr it comes back
Never cap rotThe common bad repair

Madisonville fascia repair at a glance

A fascia repair cuts out the rotten section of board along the roof edge and replaces it. On a Madisonville house the part worth checking first is the metal above it, because the parish roofing sheet calls for a drip edge at eaves and rakes, and in our experience a failed one sends water into the top of the board.

Estimated per section

$300 to $700

Replacing a rotten section of fascia, priced after the extent is opened up. Every figure here is an estimate, not a quote.

The drip edge line

R905.2.8.5

The St. Tammany Parish roofing sheet reads: “A drip edge shall be provided at eaves and rake edges and shall be overlapped not less than 2 inches.”

Rusted edging is replaced

R908.5

The same sheet reads: “Any existing flashing, edging, outlets, and vents that are rusted, damaged, or deteriorated must be replaced.”

Rot usually starts at the top

Our reasoning

In our experience, fascia rot most often starts along the top edge, where water gets past a missing, short or rusted drip edge or an overflowing gutter.

Never cap rot

The common bad repair

Wrapping a rotten board in metal hides the rot and keeps it wet. We cut the rot out and replace it with sound timber before anything covers it.

Find the cause

Or it comes back

A new board under the same failed edge metal or overflowing gutter rots again. The written scope names the cause as well as the board.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Cost and timescale depend on size, pitch, access, weather, materials and whatever is found once work starts, so call Big Easy Roofing on (504) 800-8196 and we will come out and give you an estimate for your own roof.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Call Big Easy Roofing on (504) 800-8196 about fascia on a Madisonville house.

What rots a fascia board, and what fixes the cause

In our experience, fascia rot almost always has a cause above or beside it. The table sets out the usual causes, what we check, and what the repair involves, so the fix reaches the cause as well as the board.

CauseWhat we checkWhat the repair involvesEstimated
Missing or short drip edgeWhether a drip edge is there and lappedReplace the rotten section, fit drip edge as the sheet describes$300 to $700 a section
Rusted or damaged edge metalCorrosion along the eave and rakeReplace the rusted metal and the rotten board under itPriced on the run
Overflowing gutterOutlets, fall and the hangersRepair the board and fix the gutter that soaked it$300 to $700 plus gutter work
Paint failureBare or cracked paint on the boardTreat or replace soft timber, then prime and paintPriced on the run

Every figure is an estimate and none of it is a quote. The rot is opened up before the price is final, because it often runs further along the board than the stain suggests.

What the parish roofing sheet says about the edge

St. Tammany Parish Permits and Inspections publishes a roofing sheet, dated 23 August 2023, listing some of the most overlooked sections of the 2021 International Residential Code chapter 9. Two of its lines cover the metal that sits above a fascia board.

Drip edge at eaves and rakes

Lapped at least 2 inches

The sheet reads: “A drip edge shall be provided at eaves and rake edges and shall be overlapped not less than 2 inches.”

Worn edging replaced

Rusted, damaged or deteriorated

The sheet reads: “Any existing flashing, edging, outlets, and vents that are rusted, damaged, or deteriorated must be replaced.”

What that means on our scopes

Our practice

On a fascia repair we check the drip edge above the board, replace rusted edge metal rather than paint over it, and write both into the scope.

Which office covers your address

Town or parish, by address

The sheet is published on the St. Tammany Parish Permits and Inspections page. Any permit question goes to the Town or the parish depending on the address, and Town Hall on (985) 845-7311 confirms which.

When the gutter is the cause

An overflowing gutter soaks the board it is fixed to. A new board behind the same gutter rots again.

Overflow is diagnosed on the Madisonville gutter repair page, and priced beside the fascia work.

Why we do not cap rot

Metal capping over a rotten board looks finished and keeps the rot wet underneath.

In our practice the rot comes out first, and only sound timber is covered.

Why fascia rots on a Madisonville house

Madisonville sits where the Tchefuncte River meets Lake Pontchartrain, and in our experience its humid air keeps a wet board wet for longer. The edge metal and the gutter decide whether the board gets wet in the first place, so both are checked before any timber is priced.

Water at the top edge

In our experience, without a sound drip edge, water runs behind the gutter and into the top of the board.

That is why the edge metal is checked before the board is priced.

Wind at the rake

In our experience, rake edges take wind-driven rain side on, and a loose or short edge there lets it in.

The sheet’s drip edge line covers rakes as well as eaves.

Paint as the last line

In our experience, cracked paint lets water into the grain, and primed and painted timber lasts longer.

Paint does not fix rot, so soft timber is replaced first.

Big Easy Roofing Process

Four steps. The edge metal and the gutter are checked before the board is priced.

A roofer checking a fascia board and drip edge along a roof eave
01

01 Find the cause

Drip edge, edge metal and gutter, photographed.

02

02 Open up the rot

The extent is found before the price is final.

03

03 Replace the board and fix the cause

Sound timber, primed and painted, and new edge metal where the old is rusted.

04

04 Written record

The cause, the repair and the photographs.

Everything else we do in Madisonville

The rest of the Big Easy Roofing services available in Madisonville, each with its own page and written scope. Fascia rot is usually a symptom, so the page that fixes its cause is often the gutter or the roof edge rather than this one.

Filter by service type:

Madisonville Fascia Board Repair FAQs

The questions worth asking before a fascia board is repaired on a Madisonville house.

Topic

Question not here?

Ask us anything about fascia on your Madisonville house. No charge and no obligation.

Call (504) 800-8196
How much does fascia repair cost in Madisonville?

Replacing a rotten section is estimated at $300 to $700. The price is final once the rot is opened up, because it often runs further than the stain.

Why does my fascia keep rotting?

In our experience, because the cause was never fixed: a missing or rusted drip edge above it, or a gutter overflowing into it. A new board under the same edge rots again.

What does the parish sheet say about drip edge?

It reads: “A drip edge shall be provided at eaves and rake edges and shall be overlapped not less than 2 inches.”

Can you just cover the rotten board with metal?

We do not cap rot. Capping keeps the rot wet underneath. The rot is cut out and only sound timber is covered.

Does a fascia repair need a permit?

Ask the office that covers the address; Town Hall on (985) 845-7311 confirms whether that is the Town or the parish. We ask before starting rather than assume.

Fix the fascia and the edge above it in one written scope

We check the drip edge and the gutter, cut out the rot, replace it with sound timber and write down the cause so the repair lasts. If you would rather start in writing, tell us what the job involves and we will come back with an estimate.

Call (504) 800-8196
Fascia Board Repairin Madisonville