Big Easy Roofing Logo
Claim Banner - Big Easy Roofing Big Easy Roofing roof replacement guarantee banner
Call Our Roofing Experts!(504) 800-8196
Home/Service Areas/Louisiana/River Ridge/Commercial Roof Replacement

Commercial Roof Replacement in River Ridge, LA

Big Easy Roofing handles commercial roof replacement across River Ridge and the east bank of Jefferson Parish. The east bank of Jefferson Parish sits in the hurricane-prone region under ASCE 7-16, so the system choice and the attachment are both wind-driven decisions long before they are aesthetic ones.

Four systemsTPO, EPDM, PVC, modified-bitumen
Hurricane-prone regionPer ASCE 7-16
(504) 736-6957Jefferson Parish building permits
State Fire MarshalA second office on commercial work

River Ridge commercial roof replacement at a glance

A commercial reroof on a River Ridge building runs through a short sequence of offices (Louisiana Office of State Fire Marshal plan review first, then the Jefferson Parish building permits office) and a longer sequence of system choices. Four low-slope membrane systems cover most Jefferson Parish commercial roofs, and the pick is a wind, chemistry and lifetime decision rather than a brand choice.

Four low-slope systems

TPO, EPDM, PVC, modified-bitumen

The site visit picks the system for the building, not the trend. The compare table below sets out what each one is good at and where each one is a bad fit.

Hurricane-prone region

ASCE 7-16

The east bank of Jefferson Parish sits in the hurricane-prone region under ASCE 7-16. The commercial scope specifies the wind uplift rating the design engineer sets for the address, and the membrane attachment follows from that rating.

State Fire Marshal plan review

A second office

A Louisiana commercial construction scope typically goes to the Louisiana Office of State Fire Marshal for plan review before the parish permit application. The specific threshold and the review window are the Fire Marshal office’s to answer; the scope names the step as a precondition.

Jefferson Parish permit

Same office as residential

The parish Department of Building Permits East Bank office on (504) 736-6957 answers the commercial permit question for a River Ridge address. The commercial roof repairs page carries the detail on the parish commercial permit route.

LSLBC commercial licence

Carried on the paperwork

The Louisiana State Licensing Board for Contractors sets the commercial-contractor requirement; the River Ridge commercial roof repairs page carries the threshold detail. The commercial LSLBC licence number appears on the paperwork submitted with the parish permit application.

What we will not interpret

Your insurance

A photograph of a commercial roof documents what is on it. Under R.S. 37:2159.1 a Louisiana roofing contractor may not interpret your insurance cover.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Call (504) 800-8196 for a commercial reroof walk on your River Ridge building.

Four low-slope systems, what each does well

The four common low-slope commercial systems are TPO single-ply, EPDM single-ply, PVC single-ply and modified-bitumen multi-ply. The table below is a quick comparison; the site visit picks the system for the building, the wind environment and how the roof is used.

SystemWhat it isWhere it fitsWhat to watch
TPO single-ply (thermoplastic polyolefin)A white heat-reflective single-ply membrane; seams are heat-weldedNew commercial on a sunny roof; office, retail and warehouse buildsWelding quality and attachment method matter more than brand; a poor seam is where TPO fails
EPDM single-ply (ethylene-propylene-diene monomer)A black rubber-chemistry single-ply with a long field history; seams are joined with tape or adhesiveRetrofit over sound insulation; buildings where heat gain is not a concernEPDM is not heat-reflective, so the roof will run warmer than TPO or PVC under a Louisiana sun
PVC single-ply (polyvinyl chloride)A chemically-resistant single-ply with heat-welded seams; typically reinforcedRoofs around grease vents (restaurants), chemical exhausts or standing-water tendenciesMore expensive than TPO or EPDM; a PVC-specific scope reads the ventilation and the exhausts first
Modified-bitumen multi-plyAn asphalt-based multi-ply system; torch, mop or cold-adhesive appliedRetrofit over older built-up roofs; smaller commercial buildings where single-ply does not fitInstall method (torch, mop or cold-adhesive) is a safety decision as well as a system one; the scope names which

None of these is right for every building. The site visit reads the deck, the insulation, the drainage and the exhausts first, and the system follows the reading.

The office sequence, for a River Ridge commercial reroof

A River Ridge commercial reroof passes through two offices in sequence: the Louisiana Office of State Fire Marshal reviews the plans first, and the Jefferson Parish Department of Building Permits issues the permit second, with the Fire Marshal review in hand. The written scope names each office and what it wants, so no office is a surprise halfway through.

Louisiana Office of State Fire Marshal

Plan review

The State Fire Marshal office plan reviews commercial construction above the state threshold. The specific threshold, submittal package and review timeline are the Fire Marshal office’s to confirm for a given scope; the written scope names the step rather than running the review for the owner.

Jefferson Parish Department of Building Permits

East Bank office

The parish office at 1221 Elmwood Park Blvd., Suite 101, Jefferson LA 70123, on (504) 736-6957 answers the commercial permit question. The commercial roof repairs page covers the detail of what the office has published on commercial reroofing and what it does not.

LSLBC commercial licensure

For the contractor

A commercial reroof carries an LSLBC commercial licence held by the contractor on the job; the River Ridge commercial roof repairs page carries the threshold detail. The licence number appears on the paperwork submitted with the permit application.

Our role on a commercial reroof

Coordinate the sequence and build to spec

We coordinate the office sequence (Fire Marshal submittal, parish permit application, inspection), carry the LSLBC commercial licence where the project meets the threshold, and do the reroof work. The design engineer of record stamps the plans.

What a commercial reroof scope documents

Each office in the sequence with what it wants from the submittal. The scope does not run the Fire Marshal review for the owner; it names what the owner needs to secure before the parish paperwork can proceed.

The commercial-asbestos reading, where it applies, lives on the River Ridge asbestos roof removal page. A commercial reroof that removes asbestos-containing material carries that reading alongside.

What we do not represent

We do not act as architect of record or engineer of record. Stamped plans come from the design professional engaged on the project.

We provide the roofing specification that feeds those plans and, where the project meets the LSLBC commercial threshold, the licensed commercial contractor who does the work.

Wind uplift on a Jefferson Parish commercial roof

A low-slope commercial roof on the east bank of Jefferson Parish is a wind design problem before it is a membrane choice. The hurricane-prone region designation under ASCE 7-16, the exposure category for the specific site, and the building’s risk category all set the uplift pressure the attachment has to meet.

Hurricane-prone region, by designation

ASCE 7-16 designates coastal Louisiana as a hurricane-prone region with the ultimate wind speed value set by map at the specific address. The design engineer of record reads the map and specifies the uplift pressure for the project.

The scope quotes the engineer’s pressure value; it does not pick the number itself.

Attachment follows the pressure

Three attachment methods are common for low-slope single-ply: mechanically fastened to the deck, fully adhered to the insulation with manufacturer-approved adhesive, or ballasted (less common on the Gulf Coast because loose stone becomes projectiles).

The uplift pressure the design calls for selects the method. A high-pressure design pushes toward fully adhered or heavily fastened; a low-pressure design accepts standard fastening.

Edge metal and parapet details

Low-slope roofs commonly fail at the perimeter before the field. The scope names the edge metal gauge, the fastening at the perimeter, and the parapet-cap detail. A field membrane that survives the storm with a failed edge metal is still a water-entry event.

The parish commercial permit paperwork rests on these details being named rather than left to the installer.

Big Easy Roofing Process

Four steps. The site walk comes first; the Fire Marshal and the parish office are both engaged before the work starts; and the commercial contractor on the job carries the LSLBC commercial licence where the project meets the threshold.

A commercial flat roof under replacement in a Louisiana city
01

01 Walk and specify

The site walk reads the existing membrane, the insulation condition, the attachment, the drainage and the exhausts. The specification is written against the Louisiana hurricane-prone region wind environment.

02

02 Fire Marshal plan review

The design engineer of record submits the plans to the Louisiana Office of State Fire Marshal for review on commercial construction above the state threshold. The written scope names the step.

03

03 Parish commercial permit

The permit application goes to the Jefferson Parish Department of Building Permits East Bank office on (504) 736-6957 with the Fire Marshal review in hand and the LSLBC commercial licence number on the paperwork.

04

04 Replacement and inspection

Work carried out under the issued permit, the manufacturer’s written specification for the chosen system, and the engineer’s uplift design.

Everything else we do in River Ridge

The rest of the Big Easy Roofing services available in River Ridge, each with its own page and written scope. A commercial replacement usually follows a commercial roof repairs conversation that has reached the end of its usefulness.

Filter by service type:

River Ridge Commercial Roof Replacement FAQs

Four low-slope systems, hurricane-prone region wind uplift, and the two-office sequence (Fire Marshal plus parish permit) on a River Ridge commercial reroof.

Topic

Question not here?

Ask us about a commercial reroof walk on your River Ridge building. No charge to ask.

Call (504) 800-8196
Which commercial roof system is best for a River Ridge building?

The four common low-slope systems (TPO, EPDM, PVC, modified-bitumen) each fit different buildings. The site visit reads the deck, the insulation, the drainage and the exhausts, and the system follows the reading rather than a general preference.

Who handles a commercial reroof permit in River Ridge?

The Jefferson Parish Department of Building Permits East Bank office on (504) 736-6957. River Ridge is unincorporated, so there is no city permits office for the address.

Does the Louisiana Office of State Fire Marshal review every commercial project?

A Louisiana commercial construction scope above the state threshold typically goes to the Office of State Fire Marshal for plan review. The specific threshold and the submittal package are the Fire Marshal office’s to confirm; the scope names the step as a precondition.

What LSLBC licence does a commercial reroof need?

A commercial LSLBC licence held by the contractor on the job. The River Ridge commercial roof repairs page carries the threshold detail; the licence number appears on the paperwork submitted with the parish permit application.

Who stamps the plans?

A licensed design professional (architect or engineer) engaged on the project. We provide the roofing specification that feeds those plans; the engineer sets the uplift design against the hurricane-prone region wind environment.

How is wind uplift set on a Louisiana commercial roof?

ASCE 7-16 designates coastal Louisiana as a hurricane-prone region. The design engineer of record reads the ASCE 7-16 wind map at the specific address and specifies the uplift pressure the attachment has to meet. The scope quotes that pressure rather than picking it.

What about asbestos in the existing commercial roof?

If the existing roof contains asbestos, the River Ridge asbestos roof removal page carries the NESHAP reading. A commercial reroof scope that removes asbestos-containing material carries that reading alongside the system scope.

Will my insurance pay for a commercial reroof?

That is a question for your insurer. Under R.S. 37:2159.1 a Louisiana roofing contractor may not interpret your insurance cover.

Four systems, hurricane-prone wind design, Fire Marshal plan review then the parish permit

A River Ridge commercial reroof scope names the system, the uplift design and the office sequence from the start: Louisiana Office of State Fire Marshal plan review on one side and the Jefferson Parish East Bank permit office on the other. If you would rather start in writing, tell us what the job involves and we will come back with an estimate.

Call (504) 800-8196
Commercial Roof Replacementin River Ridge