FREE Roofing Estimates
Claim Banner - Big Easy Roofing
24 Hour Roof Replacement Guarantee
Call Icon Top

Call Our Roofing Experts! (504) 800-8196

FREE Roofing Inspections
Home/Service Areas/Louisiana/Kenner/Fascia Board Repair

Fascia Board Repair in Kenner, LA

Big Easy Roofing repairs fascia across Kenner and east bank Jefferson Parish. The fascia is the board along the roof edge that carries your gutter, and it is the part of the roof a neighbour or a passer by actually notices, usually well before anything on the roof itself.

Get Your Free Fascia Quote Call (504) 800-8196
$300 to $700Estimated per section
Find the causeOr it comes back
Code sweepsKenner names fighting blight an objective
Never cap rotThe common bad repair

Kenner fascia board repair at a glance

Fascia is the board along the roof edge that carries the gutter and closes the end of the rafters. It is also the part of your roof the street can see, which is why it gets noticed long before anything else on the roof does.

The rot is a symptom

Something wet it

Timber at the roof edge does not fail on its own. A blocked or overflowing gutter, a short or missing drip edge, or water coming off the covering behind the gutter put it there. Replace the board without fixing that and the new board rots too.

Estimated per section

$300 to $700

Driven by the length of the run, the height, whether the gutter has to come off and go back, and what is behind the board. Every figure here is an estimate, not a quote.

One fault rarely wets forty feet

Replace what failed

Water gets in at a point and spreads from there, so a sound run either side of a bad section is normally still sound. We cut out and replace what has gone rather than pricing the whole elevation by default.

Never cap rot

The common bad repair

Nailing new board, aluminium wrap or a cover over decayed timber hides it and keeps it wet. It looks finished from the ground on the day and the rot carries on behind it, usually into the rafter tails.

It is the visible edge

The first thing a passer by sees

The City's code department names fighting blight as one of its main objectives and runs code sweeps across all districts. Nothing published describes what a sweep looks at, and nothing makes fascia a violation on an occupied house. The roof edge still reads from the kerb.

Check the rafter tails

Before pricing the board

Where fascia has been wet for a long time the rafter ends behind it are often soft as well. That is structural timber rather than trim, and it is better found at the quote than halfway through the job.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Cost and timescale depend on size, pitch, access, weather, materials and whatever is found once work starts, so call Big Easy Roofing on (504) 800-8196 and we will come out and give you an estimate for your own roof.

Every figure on this page is an estimate, not a quote, and is subject to Big Easy Roofing sign off. Call Big Easy Roofing on (504) 800-8196 about fascia on a Kenner house.

What the replacement board is actually made of

Fascia gets replaced in one of four materials and they behave differently in this climate. The last column is the one that decides whether you are back here in eight years, because every one of these fails at the cut end and the fixing first.

MaterialHow it holds up hereWhat it needsWhere it usually fails
Primed and painted timberGood if it is sealed on all six faces before it goes upPaint kept intact, and the cut ends primed at fittingThe cut ends and the nail holes, where water gets in first
Bare timber painted after fittingWorst of the four in this humidityA repaint far sooner than anyone expectsThe back face, which never got sealed and never dries
PVC or cellular trimDoes not rot, and moves more with heat than timber doesFixing and expansion gaps set for the movementThe joints, if it was fitted as though it were wood
Fibre cement or compositeStable and heavy, holds paint wellCorrect fixings and support, it is not a light boardCut ends left unsealed, same as timber
Aluminium wrap over old boardNot a repair at all where the board is rottenOnly appropriate over sound, dry timberLater, if damp ever reaches the timber underneath, because the wrap hides it from view

Every figure and timing on this page is an estimate rather than a quote. The common thread is that all four real materials fail at the cut end and the fixing, which is why fitting detail matters more than the material anyone chooses.

The roof edge is what the street sees, and what the City actually publishes

Kenner's Inspection and Code Enforcement Department names fighting blight as one of its main objectives and runs code sweeps across all districts of the City. Nothing it publishes describes what a sweep looks at, and nothing makes rotten fascia a violation on an occupied house.

What the department says it does

Blight and code sweeps

The Inspection and Code Enforcement Department page states that one of its main objectives is to fight blight within the City of Kenner, and that it facilitates code sweeps throughout all districts. That is the City describing its own priorities, not a rule about your roof, and it is not a published standard for an occupied home's fascia.

What the City means by kerb appeal

Ordinance 10,455

Kenner's abandoned property rules require such a property to be "maintained in a manner comparable to the neighborhood", with minimums including no evidence of vacancy, paint matched to the colour of the exterior, and landscape maintenance of visible front and side yards. Every one of those is about how the place reads from the kerb.

That ordinance is not about your house

Abandoned and vacant only

Ordinance 10,455 is scoped to abandoned and vacant property. It does not apply to an occupied home, and we are not going to tell you otherwise to sell you carpentry. It is quoted here because it is the clearest published statement of what this City considers the visible standard of a street.

What we will not claim

No citation, no fine

We will not invent a citation, a fine or a notice period for a roof edge. None of that is published anywhere and none of it is ours to say, and the department takes its own questions on (504) 468-4064. What is true is simpler: the roof edge is the first thing a buyer, a neighbour or a surveyor looks at.

Why the cause matters more than the board

Fascia is trim, and trim rots because water reached it. The usual sources are a gutter that overflows or holds water, a drip edge that stops short so run off goes behind the gutter rather than into it, or a covering failure above. Any of those will rot a new board as fast as it rotted the old one.

So the visit starts at the cause. Where water is getting into the building as well as into the trim, leak detection comes first, because the entry point is often nowhere near the wet timber.

When the fascia is telling you about the roof

A single rotten section on an otherwise sound house is carpentry. Rot appearing at several points along an elevation, or on more than one elevation, is usually the covering or the drainage rather than the trim, and replacing board after board is the expensive way to find that out.

Where more than one section has gone, a roof inspection puts the whole roof on record first, and keeping the edge on a schedule through maintenance is what stops it recurring.

Get Your FREE Quote Call (504) 800-8196

Why fascia goes first on a Kenner house

Kenner sits on the east bank of Jefferson Parish, humid for most of the year, with heavy rain arriving fast. The roof edge takes the concentrated run off from the whole slope above it, which is why fascia is among the first timber on the building to stay wet.

The edge takes all of it

Every drop that lands on a slope leaves at the same line. The fascia sits directly behind the gutter that is meant to catch it, so anything the gutter cannot take, whether it is volume, a blockage or a fall that has gone flat, ends up on the board.

That is why a gutter problem shows up as a trim problem, and why the trim gets replaced while the actual fault stays where it is.

Humidity keeps it from drying

Timber here rarely gets a long dry spell to recover in. A board that is wetted repeatedly and never fully dries decays from the back face, so the painted front can look reasonable while the timber behind it has gone.

Pressing the board at the joints and the cut ends tells you more than looking at it does, and it is worth doing before the paint is what makes the decision.

What we check while we are up there

The drip edge, the gutter fall, the state of the covering at the eave, and the rafter tails behind the board. Those four decide whether this is a trim job or the visible end of something larger.

Where the answer is the covering rather than the edge, a roof repair is the honest scope and we will say so rather than sell the carpentry twice.

Big Easy Roofing Process

Four steps. The first one is about water rather than timber, because a board replaced without finding what wet it is a repeat visit with a receipt.

A roofer checking a rotten fascia board and the rafter tail behind it at the roof edge
Get Your FREE Quote Call Our Roofing Experts!
01

01 Find what wet the board

Gutter fall and blockages, the drip edge, and the covering at the eave. The cause is fixed or scoped in the same visit, not left for later.

02

02 Sound the run and mark the real extent

Press and probe along the board and check the rafter tails behind it, so the scope is what has actually failed rather than the whole elevation by default.

03

03 Write the scope, the material and the value

Which sections are coming out, what is going back, and the figure, with anything structural behind the trim named before the work starts rather than found halfway through.

04

04 Cut out, replace, seal every face, make good

New board sealed on all faces including the cut ends, gutter refitted to a working fall, and the edge left painted to match.

Everything else we do in Kenner

The other Big Easy Roofing services we run in Kenner, each with its own crew and written scope, and more of them going live here page by page. Fascia is the visible end of a problem that usually starts above it, which is why the cause gets found before any board is priced.

Filter by service type:

Kenner Fascia Board Repair FAQs

Why the board rotted, how much of it actually has to come out, and what the City of Kenner does and does not say about the look of a property.

Topic

Question not here?

Ask us about the roof edge on your Kenner house. No charge and no obligation.

Call (504) 800-8196
Why did my fascia rot in the first place

Something wet it and kept it wet. Usually a gutter that overflows, holds water or has lost its fall, a drip edge that stops short so run off goes behind the gutter, or a covering failure at the eave. Timber at the roof edge does not fail on its own.

Can you just replace the board

We can, and on a single failed section with a cause that is already fixed that is the right job. What we will not do is fit a new board under a fault that is still running, because the new timber will go the same way as the old.

Do you have to replace the whole run

Usually not. Water gets in at a point and spreads from there, so the run either side of a bad section is often still sound. We sound the board along its length and replace what has actually failed.

What if the timber behind the fascia is soft too

Then it is named before the work starts. Where fascia has been wet a long time the rafter ends behind it can be affected, and that is structural timber rather than trim, so it is a different scope and a different figure.

Can the City of Kenner cite me for rotten fascia

Nothing the City publishes says so, and we are not going to suggest otherwise. What the Inspection and Code Enforcement Department does publish is that fighting blight is one of its main objectives and that it runs code sweeps across all districts. Its published minimum standards for appearance sit in Ordinance 10,455, which applies to abandoned and vacant property rather than to an occupied home.

What does Kenner consider the visible standard of a street

The closest published answer is Ordinance 10,455, which requires an abandoned property to be maintained in a manner comparable to the neighborhood, with minimums including no evidence of vacancy, paint matched to the colour of the exterior, and landscape maintenance of visible front and side yards. Again, that ordinance covers abandoned and vacant property only.

What does fascia repair cost in Kenner

Estimated at $300 to $700 per section, driven by the length, the height, whether the gutter has to come off and go back, and what is found behind the board. Every figure here is an estimate and a written price follows a look at the edge.

Should the new board be timber or PVC

Either works when it is fitted properly. Timber has to be sealed on all six faces including the cut ends before it goes up. PVC will not rot but moves more with heat than timber does, so its fixings and expansion gaps have to be set for that. Both fail at the joints when they are fitted as though they were the other one.

Fix the roof edge and what wet it so the new board lasts

Fascia is trim, and trim rots because water reached it. We find the gutter, drip edge or covering fault that put it there, replace only the sections that have actually failed, seal every face including the cut ends, and tell you plainly if the rafter tails behind the board have gone as well. The roof edge is the part of your house the street sees, and it is worth getting right once. If you would rather start in writing, tell us what the job involves and we will come back with an estimate.

Call (504) 800-8196
Fascia Board Repairin Kenner